ꁲ
ꁲ
ꁲ
GX Sand Washer
GX series wheelstype sand washing machine is a kind of wheel bucket sand washing machine, which can clean and separate stone powder and soil in sand and gravel. Its novel sealing structure and reliable transmission device ensure the effect of cleaning and dehydration. It is used in conjunction with sand making equipment. An efficient wheel bucket type sand washing machine.
Applicable materials: medium and fine grain size and coarse grain size materials
Feed particle size: ≤ 10mm
Production capacity: 20-150 T/H
application scope: highway, water and electricity, construction site, sand making, cleaning, grading and dehydration
视频播放失败，请联系站点管理员！
Performance Characteristics
The wheel typesand washing machinehas reasonable structure, convenient maintenance, large processing capacity, low power consumption and cleaning degree.,
sand loss is small in the process of sand washing, especially its transmission part is isolated from water and sand, and its failure rategreatly
is lower than the commonly used spiral sand washing machine.
Technical Parameters
|
Model specifications |
impeller specifications (mm) |
impeller speed(r/min) |
(t/h) |
feed particle size (mm) |
water consumption (t/h) |
motor power (kw) |
reducer model |
Dimensions (mm) |
|
GX2610 |
φ 2600*1000 |
1.178 |
20-50 |
≦ 10 |
20-60 |
6-pole 5.5 |
ZQ40-50-I-Z |
3255*1982*2690 |
|
GX2915 |
φ 2900*1500 |
1.177 |
30-60 |
≦ 10 |
50-100 |
8 pole 11 |
ZQ65-50-I-Z |
3540*3000*2880 |
|
GX3016 |
φ 3000*1600 |
1.176 |
50-120 |
≦10 |
70-120 |
8 pole 15 |
ZQ65-50-I-Z |
3845*3000*3080 |
|
GX3020 |
3000*2000 |
1.176 |
70-150 |
≦10 |
100-160 |
8 pole 15 |
ZQ65-50-I-Z |
3845*3400*3080 |
Note: The above contents are for reference only. The actual samples shall prevail. The data in the table are subject to change without prior notice.
Works
The washed sand is injected into the sand washing tank through the chute, and the sand in the water is dug and loaded into the wheel bucket with a rotating bucket wheel. The bucket wheel is gradually dehydrated during the rotation and lifting process until the bucket wheel is turned to the discharging end, the washed sand is poured into the discharging chute, and then transported to the sand stacking site by a belt conveyor.
The transmission system is transmitted from the small pulley installed on the motor to the large pulley through the V-belt to decelerate, and then decelerated by the JZQ reducer for the second time, and the output shaft end is decelerated for the third time by a pair of gears to drive the bucket wheel drive shaft, So that the bucket wheel works at a slow speed of about one revolution per minute.
